QuoteOperationTimingInput
Routing selections and optional measured phase times for one inferred operation; omitted times use compatible machine profiles.
Fields
Index in the inferred operation DAG
Optional eligible work center selection; requires workCenter:read or list
Optional process selection; validated against capability and material constraints
Explicit fixed setup seconds, including zero; independent of output quantity
Explicit total run seconds, including its waste allowance; never multiplied by waste again
Net machine production quantity before waste; required with productionUnit for unitless defaultProcessingRate or unavailable layout conversions
Physical unit of productionQuantity; typed metres/minute profiles normalize length inputs to metres; unitless default rates retain the supplied unit
Possible values (15)
CLICKA billing counter rather than a physical measure: one metered page charged under a cost-per-click press or copier contract.
CMCentimetres — metric length, a hundredth of a metre.
FTFeet — imperial length, twelve inches.
GGrams — metric mass, for light items stocked by weight.
IMPRESSIONA production counter rather than a physical measure: one pass of one sheet through a press. Distinct from SHEET, since a sheet printed on both sides can cost two impressions.
INInches — imperial length, the unit paper sizes are quoted in outside metric markets.
KGKilograms — metric mass, the usual unit for reel and other bulk substrate stock.
LBPounds — imperial mass, roughly 0.45 kg.
MMetres — metric length, the usual unit for material bought by the running metre such as a reel or a roll of laminate.
MMMillimetres — metric length, a thousandth of a metre, and the granularity trim sizes and other sheet dimensions are normally given in.
OZOunces — imperial mass, a sixteenth of a pound.
PCPieces: a plain count of discrete items, carrying no dimension at all. The unit stock and transfer quantities fall back to when none is given.
PTPoints — the typographic length unit of one seventy-second of an inch, used for type sizes and rule weights rather than for stock quantities.
REPEATOne printed repeat of a web: a cut-off in web offset, a repeat in flexo and labels. What a roll press counts when it produces signatures.
SHEETA count of substrate sheets, the usual unit for sheet-fed stock. Counts the physical sheets held or moved, not the press passes over them (see IMPRESSION).
Referenced by (1)
Exact type SDL
"""
Routing selections and optional measured phase times for one inferred operation; omitted times use compatible machine profiles.
"""
input QuoteOperationTimingInput {
"""Index in the inferred operation DAG"""
operationIndex: Int!
"""
Optional eligible work center selection; requires workCenter:read or list
"""
workCenterId: WorkCenterID
"""
Optional process selection; validated against capability and material constraints
"""
capabilityId: CapabilityID
"""
Explicit fixed setup seconds, including zero; independent of output quantity
"""
setupDurationSeconds: Float
"""
Explicit total run seconds, including its waste allowance; never multiplied by waste again
"""
runDurationSeconds: Float
"""
Net machine production quantity before waste; required with productionUnit for unitless defaultProcessingRate or unavailable layout conversions
"""
productionQuantity: Float
"""
Physical unit of productionQuantity; typed metres/minute profiles normalize length inputs to metres; unitless default rates retain the supplied unit
"""
productionUnit: MeasurementUnit
}